DSL configuration
24
3088/I Getting Started Guide
3 • G.SHDSL config and status
DSL configuration
By going to the
Configuration
hyperlink in the
Configuration Menu
, you can configure the DSL link to specific
parameters if the 3088/I is not used in the Plug ‘n’ Play mode. They are listed as follows.
Note
After changing the parameters in the
DSL Configuration
section of the web
page, they take immediate effect upon clicking the
Configure
button.
Figure 8. DSL Configuration
DSL Parameters
•
Circuit ID
: The circuit ID communicated to other units via EOC. EOC (embedded operations channel) is
an out-of-band channel specified in the G.991.2 standard for SHDSL. We use standard EOC messages for
our remote loopback. The 3088/I also supports proprietary EOC messages that allow a 3096RC to
configure it.
•
Intended DSL Data Rate
: This selects the desired DSL data rate.
•
Actual DSL Data Rate (kbps)
: The actual current data rate that the DSL link is operating, minus the DSL
overhead (8 kbps).
•
Annex Type
: Either G.991.2 Annex A or Annex B.
•
Device Type
: The two options are
Remote
(default) or
Central
. When configuring two units back-to-back,
one must be remote, the other central.
•
Line Probe
: The line probe may disabled (default) or enabled for rate adaptive applications.
•
Action:
To initiate the DSL link, select
Start
and click on the
Configure
button. To take the DSL link
down, select
Deactivate
and click on the
Configure
button.
Summary of Contents for RocketLink-G 3088/I
Page 7: ...7 3088 I Getting Started Guide Table of Contents RS 232 console interface pin assignments 61...
Page 9: ...9 List of Tables 1 General conventions 13...
Page 14: ...14 Chapter 1 General information Chapter contents RocketLink G 3088 I overview 15 Features 15...
Page 56: ...56 Appendix D RJ 11 non shielded DSL port Chapter contents RJ 11 non shielded DSL port 57...
