DSL Error Monitor Configuration
25
3088/I Getting Started Guide
3 • G.SHDSL config and status
DSL Error Monitor Configuration
The DSL Error Monitor provides various statistics for the DSL line. The monitor parameters are configured
here. The error counters are also cleared from this menu.
Figure 9. DSL Error Monitor Configuration
The following shows the relationship of the DSL Error Monitor parameters:
The DSL error monitor inspects intervals to see if they have met the error threshold (Max Interval Errors). If
the error monitor finds a certain number (Interval Count) of intervals that meet or exceed the error threshold,
it will restart the DSL link. The error monitor will wait (Start Up Delay) seconds after the DSL link comes up
before it begins monitoring errors. After the startup delay, it will check the number of errors that have occurred
during each (Interval Time) seconds to see if they meet the error threshold. The error monitor inspects (Total
Intervals) intervals before it stops.
Note
Setting
Max Interval Errors
to
0
disables the error monitor and setting
Total Intervals
to
0
causes the error monitor to run continuously.
The following commands configure the error monitor:
•
Error Monitor Max Interval Errors
: Sets the number of errors allowed in an interval causes it to be consid-
ered an errored interval. If this is set to
0
, then the error monitor is disabled.
•
Error Monitor Interval Time (sec)
: Sets the length of each interval.
•
Error Monitor Interval Count
: Sets the number of errored intervals that causes the DSL link to restart.
•
Error Monitor Total Intervals
: Sets the number of intervals to inspect for errors before disabling the error
monitor. If this is set to
0
, then the error monitor will run continuously.
•
Error Monitor Start Up Delay:
Sets the number of seconds to wait after the DSL link comes up before the
error monitor starts inspecting intervals.
Startup Delay
Interval #1
Interval #2
…
Interval #Total
Intervals
Õ
Start Up Delay
Ö
Õ
Interval Time (sec)
Ö
Õ
Interval Time (sec)
Ö
Õ
Interval Time (sec)
Ö
Õ
Interval Time (sec)
Ö
Summary of Contents for RocketLink-G 3088/I
Page 7: ...7 3088 I Getting Started Guide Table of Contents RS 232 console interface pin assignments 61...
Page 9: ...9 List of Tables 1 General conventions 13...
Page 14: ...14 Chapter 1 General information Chapter contents RocketLink G 3088 I overview 15 Features 15...
Page 56: ...56 Appendix D RJ 11 non shielded DSL port Chapter contents RJ 11 non shielded DSL port 57...
