Installing the Patton SmartNode Gateway
25
SmartNode 4130User Manual
3
• SmartNode Installation
Installing cables
WARNING
Do not work on the system or connect or disconnect
cables during periods of lightning activity.
WARNING
The Interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
Connect the cables in the following order:
1.
Connect the ISDN terminals and NT to the BRI ports (see section
“Connecting ISDN terminals and NT
to the SmartNode’s ISDN BRI ports”
)
2.
Connect the 10/100/1000Base-T Ethernet WAN (see section
“Connecting the 10/100/1000Base-T Ether-
)
3.
Connect the power mains cable (see section ,
Connecting ISDN terminals and NT to the SmartNode’s ISDN BRI ports
The SmartNode comes with two or four ISDN BRI ports located on the rear panel (see
on page 16). All
port can be connected to the PSTN (ISDN NT) or terminals.
CAUTION
For the ISDN connection to a carrier Network, it shall be con-
nected to a Network Termination Device and not connected
directly to an outside POTS line.
Note
On Lifeline Relay models (/R option) the PSTN line should be connected to
www.patton.com
).
For details on the BRI port pinout and ISDN cables, refer to
Appendix
.
Connecting the 10/100/1000Base-T Ethernet WAN cable
The SmartNode 4130 has automatic MDX (auto-cross-over) detection and configuration on the Ethernet port.
The port can be connected to a host or hub/switch with a straight-through wired cable.
•
Connect to the subscriber port of the broadband access modem (DSL, cable, WLL) to ETH 0/0.
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 42 and
Appendix
