Introduction
43
SmartNode 4130 User Manual
C
• Cabling
Introduction
This section provides information on the cables used to connect the SmartNode to the existing network infra-
structure and to third party products.
Serial Console
The SmartNode can be connected to a serial terminal over its serial console port, as depicted in
.
CAUTION
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceabilty.
CAUTION
For the ISDN connection to a carrier network, it shall be con-
nected to a network termination device and not connected
directly to an outside POTS line.
Note
A Patton Model 16F-561 RJ45 to DB-9 adapter is included with
each SmartNode Series device
Serial Terminal
12V, 1A
BRI 0/3
BRI 0/2
BRI 0/1
BRI 0/0
ETH 0/0
USB
Co
ns
ole
Re
s
et
Figure 9. Connecting a serial terminal
Console Connection settings:
•
19200 Bps
•
8bits, no parity
•
1stop bit
•
flow control off
Note
on page 47 for console port pin-outs.
