SmartNode 4650 overview
18
SmartNode 4650 Getting Started Guide
1 • General information
Figure 3. SmartNode 4650 front panel
G.SHDSL/ADSL
port (option)
Provides up to 5.7 Mbps (G.SHDSL) or 8 Mbps (ADSL) symmetrical throughput, sup-
porting ATM QoS. Supports multiple PVC and DSLAM interoperability.
The DSL LEDs are located on either side of the DSL port. ACT (when lit or blinking)
shows Activity, and LINK (when lit) shows that the DSL port is connected.
Reset
The reset button (see
figure 2
) has three functions:
•
Restart the unit with the current startup configuration—Press (for less than 1 second)
and release the
Reset
button to restart the unit with the current startup configuration.
•
Restart the unit with factory default configuration—Press the
Reset
button for
5 seconds until the
Power
LED (see
figure 3
on page 18) starts blinking to restart
the unit with factory default configuration.
•
Restart the unit in bootloader mode (to be used only by trained SmartNode tech-
nicians)—Starting with the unit powered off, press and hold the
Reset
button as
you apply power to the unit. Release the
Reset
button when the
Power
LED starts
blinking so the unit will enter bootloader mode.
Table 2. Rear panel ports (Continued)
Port
Description
Power
Run
VoIP Link
ENET 0
Act/Link
ENET 0
100
ENET 0
Act/Link
ENET 0
100
BRI 0
Active
BRI 0
Link
BRI 1
Link
BRI 3
Active
BRI 3
Link
BRI 4
Link
BRI 2
Link
BRI 1
Active
BRI 2
Active
BRI 4
Active
BRI 0
Active
BRI 0
Link
BRI 1
Link
BRI 2
Link
BRI 1
Active
BRI 2
Active
SN4658
SN4654
