SmartNode devices overview
18
SmartNode 5540 & 4140 Series User Manual
1
• General information
SmartNode SN4140 Series VoIP Gateway
The SmartNode SN4140 Series are compact VoIP Gateways that support 2 to 8 VoIP calls (see
Depending on the model, they have 1 or 2 Ethernet ports.
The 2 Ethernet port SN4140 models (SN4141/2ETH...) do not support IP routing. See the product accesso-
ries for software license options to enable it.
Table 3. SmartNode 5540 LED Definitions
LED
Description
Power
When lit, indicates power is applied. Blinks fast during bootloader phase and blinks
slow during the boot process . Becomes solid when the system is up and running.
VoIP
•
When lit, indicates the SmartNode device is registered to a SIP server, or a SIP
device has registered to the SmartNode device.
•
Off indicates the unit is not configured or registered, or has no active directly routed
VoIP connection.
AUX 1
On when connected to Patton
AUX 2
Auxiliary LED for future use.
Voice Ports
FXS 0–FXS 7
•
When lit, indicates FXS port is enabled. Flashes when there are ongoing or ringing
calls.
•
Off when no line or phone is connected or the port is shut down.
Voice Ports
FXO 0–FXO 7
•
In ‘Idle’ state LED is off
•
In ‘Dialing’ or ‘Ringing’ state blink-frequency is 2 per second,
•
In ‘Connected’ state blink-frequency is 1 per second
ETH 0 & ETH 1
•
When lit, indicates the Ethernet connection on the corresponding port has a link
indication.
•
Flashes when data is received or transmitted at the corresponding Ethernet port.
GIG 0 & GIG 1
•
When lit, indicates Ethernet is connected to a 1000Mb network.
•
Off when Ethernet is connected to a 10Mb or 100Mb network or not connected.
