Wall mounting
24
FiberPlex FPX6000 Series User Manual
3
• Hardware Installation
1.
Place an FPX6000 at one of the mounting locations on the rack-mounting bracket as shown in
.
The front panel should be visible through the front of the bracket as shown in
Figure 11. Two FPX6000 devices installed in a rack-mounting bracket
2.
Use 4 mounting screws included with the bracket to secure the FPX6000 to the bracket (see
3.
If there is not another FPX6000 to install in the bracket, go to step 4. Otherwise, use the remaining 4
mounting screws to secure the second FPX6000 to the bracket (see
).
4.
Place the rack mounting bracket at the desired location in the rack (verify that the bracket is level), then
secure it to the rack using 4 rack screws.
The device or devices are installed in the rack. Refer to section
Wall mounting
Do the following to mount the device on a wall using the VESA mounting bracket (see
1.
Place the VESA bracket at the desired location where it will be installed. Using the 100=mm holes in the
bracket as a template (see
on page 21), make a mark inside each of the 4 holes where the mounting
hardware for hanging the device will be installed.
2.
Install the bracket using mounting hardware appropriate for the wall material.
3.
Place the FPX6000 in the bracket as shown in
4.
Use the 4 mounting screws included with the bracket to secure the FPX6000 in the bracket (see
The device is installed. Refer to section
