Regulatory Information
33
FiberPlex FPX6000 Series User Manual
A
• Compliance Information
Regulatory Information
EMC Directive:
•
EMC: CE, FCC, EN 55032/24
•
EMI: CISPR 32, FCC Part 15B Class A
•
EMS: IEC 61000-4-2 ESD: Contact: 6KV; Air: 8KV
•
IEC 61000-4-4 EFT: Power: 2KV; Signal: 2KV
•
IEC 61000-4-5 Surge: Power: 2KV; Signal: 2KV
Low Voltage Directive:
•
Safety: LVD (EN60950-1)
•
Vibration: EN 60068-2-6
Environmental:
•
Shock: EN 60068-2-27
•
Free Fall: EN 60068-2-32
Radio and TV Interference (FCC Part 15)
This equipment has been tested and found to comply with the limits for a Class-A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation:
CE Declaration of Conformity
This device is in compliance with the essential requirements and other relevant provisions of Directive 2004/
30/EC relating to electromagnetic compatibility. Council Directive 2014/35/EU on the approximation of the
laws of the member states relating to electrical equipment designed for use within certain voltage limits. The
Declaration of Conformity may be obtained from Patton Electronics, Inc at www.patton.com/certifications.
The safety advice in the documentation accompanying this device shall be obeyed. The conformity to the
above directive is indicated by CE mark on the device.
