FPX6000 Quick Start Guide
11
Figure 10.
Transmitter rear panel ports
“Installing cables on the FPX6000R Receiver”
.
8.2 Installing cables on the FPX6000R Receiver
Do the following:
1. Install cables on the front panel of the FPX6000R (see
on page 10) as fol-
lows:
– If you are connecting a USB keyboard and mouse, connect the keyboard to
USB 1
and the mouse to
USB 2
.
2. Open the Windows Device Manager on the PC host and verify that you see the fol-
lowing device: “Mouse, keyboard & pen: Dante AV PDS keyboard/mouse”.
3. Install cables on the rear panel of the FPX6000R Receiver (see
12) as follows:
– Connect the HDMI 2.0/1.4b video endpoint (a high-quality 4K monitor is recom-
mended) to the
HDMI Output
port.
– If you are daisy-chaining multiple devices, connect the Ethernet cable to the
ETH2
port.
ETH2 will not provide PoE power to a daisy-chained device.
The USB ports can only be used by HID-class devices such as a keyboard and
mouse. USB flash drives and hard drives are not supported.
If a 1080p monitor is used instead of a 4K monitor, the FPX6000R will automat-
ically scale the 4K output to 1080p.
ETH2 will not provide PoE power to a daisy-chained device.
