SmartNode 10200 Series Quick Start Guide
7
6.1 Connecting the console serial port
1.
Connect a CAT5 RJ-45 (male-male) cable (supplied with unit) between the COM port of your computer
and the serial port (labeled 1010) of the SN10200.
2.
If your computer’s serial port features a DB9 connector, use the DB9 to RJ-45 adapter supplied with your
SN10200. If your computer's serial port features a USB connector, you will need to provide a USB to DB9
adapter.
Figure 7.
Connecting the console serial port
6.2 Connecting the Ethernet management interface
1.
Connect the supplied CAT5 Ethernet cable to the management port labeled Ethernet on the front of the
SmartNode 10200.
2.
Log into the SmartNode using the specific credentials included on the “Important Notice” sheet that
shipped with your unit. The management port is configured with a static Class C IP address by default.
Figure 8.
Connecting the management interface
7.0 Configuring the SmartNode
You may access the SmartNode through the console management port, or through the Ethernet management
port. Refer to the following sections for more information:
•
7.1 “Accessing the SmartNode via the Console Management port”
on page 8
•
7.2 “Accessing the SmartNode via the Ethernet Management port”
on page 8
SmartNode
™
Console
Ethernet
Power
TDM +VoIP Smart Media Gatewa
y
Management
Serial Console
Management Port
Serial Terminal (PC)
Note
A Patton Model 16F-561 RJ45 to DB-9 adapter is included with
each SmartNode 10200 Series device
SmartNode
™
Console
Ethernet
Power
TDM +VoIP Smart Media Gateway
Management
Ethernet
Management Port
