Analog FXS
67
SmartNode 4520 & 4110 Series User Manual
C
• Cabling
Analog FXS
CAUTION
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
Applicable to SmartNodes equipped with FXS ports. The FXS ports are connected to analog terminals
(phones, fax machines, answering machines) via cables terminated with RJ-11 connectors (see section
on page 71 for details on port pinouts).
Figure 32. Connecting an FXS device
Analog FXO
CAUTION
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
Applicable to SmartNodes equiped with FXO ports. The FXO ports are connected to analog phone lines via
cables terminated with RJ-11 connectors (see section
on page 71 for details on port pinouts).
Note
The phone line socket (connector type and pinout) available from the public
network vary from country to country. Refer to technical information avail-
able from your local operator for additional cabling information.
Summary of Contents for SmartNode 4110 Series
Page 46: ...46 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 47...
Page 72: ...72 Appendix E SmartNode 4110 Series factory configuration Chapter contents Introduction 73...
Page 74: ...74 Appendix F SmartNode 4520 Series factory configuration Chapter contents Introduction 75...
Page 76: ...76 Appendix G Installation checklist Chapter contents Introduction 77...
