Configure the Desired IP Address
30
SmartNode 4131 User Manual
4
• Initial Configuration
Figure 8. SN4131 with 1 Ethernet port: Connecting the SmartNode to the LAN
The SmartNode comes with a built-in DHCP client and a fixed IP address to simplify configuration. The
SmartNode will receive an IP address from the DHCP server in the network or it can be directly accessed using
the static IP address.
Configure the Desired IP Address
Factory-default IP Settings
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 5.
Both Ethernet interfaces are activated upon power-up. LAN interface
ETH 0/1 (LAN)
provides a default
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.
If these addresses do not match with those of your network, go to the following section to change the addresses
and network masks.
Note
IP routing is disabled on SN4131 models. See software license options to
enable it.
Table 5. Factory Default IP Address and Network Mask Configuration
IP Address
Network Mask
WAN Interface Ethernet 0 (ETH 0/0)
DHCP
DHCP
LAN Interface Ethernet 1 (ETH 0/1)
192.168.1.1
255.255.255.0
DHCP Address Range
192.168.1.10–192.168.1.99
255.255.255.0
