SmartNode devices overview
16
SmartNode 5541 & 4141 Series User Manual
1
• General information
On the products the following model code conventions apply:
•
JS
stands for FXS ports
•
V
stands for number of voice channels
•
SP
stands for surge protection (K.21 compliant)
1
•
EUI
stands for external universal input power supply
Note
For a complete listing of available models, refer to the SmartNode VoIP page
at
https://www.patton.com/products/voip-comparison.asp
Port descriptions
The SmartNode 5541 Series rear panel ports are described in
Reset button behavior
For those SmartNode devices that have a
Reset
button on the rear panel, its behavior is as follows:
•
To restart the unit with the current startup configuration—Press for less than 1 second and release the
Reset
button. The SmartNode will restart with the current startup configuration.
•
To restart the unit with factory default configuration—Press the
Reset
button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
•
To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with the
unit powered off. Press and hold the
Reset
button while applying power to the unit. Release the
Reset
button
when the
Power
LED starts blinking so the unit will enter bootloader mode.
Furthermore the
Reset
button may be used to perform a system software image switch as follows:
1.
Hold the
Reset
button during boot. The power LED flashes quickly for 2 seconds, during which time the
Reset
button must remain pressed The power LED will begin a blink pattern (described in
Table 2. Rear panel ports
Port
Location
Description
10/100/100 Ethernet
ETH 0/0 & ETH 0/1
Rear panel RJ-45 connectors that connect the SmartNode device to an Ethernet device
(e.g., a cable or DSL modem, LAN hub or switch).
Analog voice port,
FXS
Rear panel FXS RJ-11(6 position, 4 wire) connectors that connect the device with an
analog terminal (a telephone, for example). FXS on-hook voltage is 48V
for each FXS port.
Power
Rear panel The SmartNode device requires 12 VDC, 1.25 A power for operation.
Every SmartNode device comes with an external power supply converting
from AC to DC power (100–240 VAC, 50/60 Hz).
USB 2.0
Rear panel USB 2.0 host port used to connect a USB 3G/4G cellular modem. A list of
