Installing the gateway router
26
SmartNode 4650 ADSL2+ Getting Started Guide
3 • SmartNode installation
Installing the DSL cable
The SmartNode Model 4650 comes with an ADSL2+ interface. Use a straight-through RJ-11 cable to connect
the DSL port.
Connecting the power supply
The SmartNode 4650 ADSL2+ models have internal and external AC power supplies available.
Internal AC Power Supply.
Do the following to connect the internal AC power supply:
Note
Do not connect the power cord to the AC power outlet at this time.
1.
Insert the female end of the AC power to the mains port (see
figure 2
on page 15).
2.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to
“Contacting Patton for assistance”
on page 42 to find out how to replace it with a compatible
power cord.
3.
Connect the male end of the AC power cord to an appropriate AC power outlet.
Figure 6. Power LED (SmartNode 4658 shown)
4.
Verify that the green
Power
LED is lit (see
figure 6
).
External AC Power Supply.
Do the following to connect the external AC power supply.
The internal power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
CAUTION
Power
