Installing the gateway router
27
SmartNode 4650 ADSL2+ Getting Started Guide
3 • SmartNode installation
Note
Do not connect the power cord to the power outlet at this time.
1.
Insert the barrel type connector end of the AC power adapter into the power supply connector on the
SN465x unit (see
figure 7
).
2.
Insert the female end of the power cord into the AC power adapter.
Figure 7. Power connector location on rear panel
3.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to chapter 6,
“Contacting Patton for assistance”
on page 42 to find out how to replace it with a com-
patible power cord.
4.
Connect the male end of the power cord to an appropriate power outlet.
5.
Verify that the green
Power
LED is lit (see
figure 6
).
Internal S-Bus power supply
The Model 4650 supplies S-Bus line power on the BRI ports that can be activated individually for each port. If
a port is switched to TE mode, line power is switched off. A total of 4W are available.
Congratulations, you have finished installing the SmartNode Gateway Router! Now go to chapter 4,
“Initial
configuration”
on page 28.
The external power supply automatically adjusts to accept an
input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
ACT
LINK
Power
12V
, 1.25A
–
+
CAUTION
