2. Configuring the desired IP address
30
SmartNode 4650 ADSL2+ Getting Started Guide
4 • Initial configuration
SmartNode will provide the PC with an IP address. You can check the connection to the SmartNode by exe-
cuting the ping command from the PC command window as follows:
ping 192.168.1.1
2. Configuring the desired IP address
Factory-default IP settings
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
table 5
.
Both Ethernet interfaces are activated upon power-up. LAN interface
ETH 0/0 (LAN)
provides a default
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.
If these addresses match with those of your network, go to section
“3. Connecting the SmartNode to the net-
work”
on page 31. Otherwise, refer to the following sections to change the addresses and network masks.
Note
For configuring the IP address of the ADSL interface, please refer to Chapter
5,
“DSL Basic Configuration”
on page 37.
Login
To access the SmartNode, start the Telnet application. Type the default IP address for the router into the
address field:
192.168.1.1
. Accessing your SmartNode via a Telnet session displays the login screen. Type the
factory default login:
administrator
and leave the password empty. Press the
Enter
key after the password
prompt.
login:
administrator
password: <Enter>
192.168.1.1>
After you have successfully logged in you are in the operator execution mode, indicated by > as command line
prompt. With the commands
enable
and
configure
you enter the configuration mode.
192.168.1.1>
enable
192.168.1.1#
configure
192.168.1.1(cfg)#
Changing the WAN IP address
Select the context IP mode to configure an IP interface.
192.168.1.1(cfg)#
context ip router
192.168.1.1(ctx-ip)[router]#
Table 5. Factory default IP address and network mask configuration
IP Address
Network Mask
LAN interface Ethernet 1 (ETH 0/0)
192.168.1.1
255.255.255.0
DHCP address range
192.168.1.10–192.168.1.19
255.255.255.0
