CodesSmartNode 5480 and 5490 Series Rear Panels
16
SmartNode 5480 & 5490 User Manual
1
•
General Information
CodesSmartNode 5480 and 5490 Series Rear Panels
SmartNode 5480 Rear Panel
The SmartNode 5480 Series rear panel ports are described in
Table 4
.
Figure 2. SN5480 rear panel
Table 4. SN5480 rear panel ports
Port
Description
WAN ETH 0/0
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
Figure 2
), connects the unit to an Ethernet
WAN device (for example, a cable modem, DSL modem, or fiber modem). Note:
Only full duplex modes are supported.
LAN ETH 0/1
Auto-MDX Gigabit-Ethernet port, RJ-45 (see
Figure 2
), connect the unit to an Ethernet
LAN (for example, a PC, printer, or wireless bridge). Note: Only full duplex modes
are supported.
Console
Used for service and maintenance, the Console port (see
Figure 2
), an RS-232 RJ-45
connector, connects the product to a serial terminal such as a PC or ASCII terminal
(also called a dumb terminal).
12V DC, 1.0A
Electricity supply socket. (See
Figure 2
.)
Reset
The reset button (see
Figure 2
) has three functions:
•
Restart the unit with the current startup configuration—Press (for less than 1 second)
and release the
Reset
button to restart the unit with the current startup configuration.
•
Restart the unit with factory default configuration—Press the
Reset
button for
5 seconds until the
Power
LED (see
Figure 4
on page 19
) starts blinking to restart the
unit with factory default configuration.
•
Restart the unit in bootloader mode (to be used only by trained SmartNode techni-
cians)—Starting with the unit powered off, press and hold the
Reset
button as you
apply power to the unit. Release the
Reset
button when the
Power
LED starts blink-
ing so the unit will enter bootloader mode.
