SmartNode SN5530 Overview
18
SmartNode 5530 User Manual
1
• General Information
on page 19 shows SN5530 front panel LEDs, and includes descriptions of the
LEDs.
Table 2. Rear panel ports
Port
Description
ETH 0/0 & ETH 0/1
Auto-MDX Fast-/Gigabit-Ethernet port, RJ-45 (see
), connects
the unit to an Ethernet WAN device (for example, a cable modem, DSL
modem, or fiber modem).
USB 2.0
USB 2.0 host port (see
) to connect a USB 3G/4G Cellular
Modem.
A list of supported USB Models can be found in the release notes and in
the Software Configuration Guide
BRI 0/0 - BRI 0/7
ISDN BRI TE/NT port, RJ-45 socket S0/T0 interface (see
), con-
nects the SmartNode with an ISDN device over an S/T bus, e.g. a PBX or
an NT.
The port can be switched between TE and NT mode.
The interface is internally terminated with 100 Ohm.
Point-to-point or point-to-multipoint configurable. If the port is in NT
mode, a Phantom power supply can be switched on to supply connected
phones with power.
Console
Used for service and maintenance, the console port (see
page 17) an RS-232 RJ-45 connector, connects the product to a serial
terminal such as a PC or ASCII Terminal (also called a dumb terminal).
Configuration settings:
•
19200 bps
•
8 bits, no parity
•
1 stop bit
•
flow control off
12V DC, 1A
Electricity supply socket. (see
Reset
The reset button has several functions, as described in appendix F,
Expansion Port
G.SHDSL,VDSL-
ADSL, SFP
The G.SHDSL, VDSL-ADSL, SFP or RJ45 Ethernet LEDs are located on
either side of the DSL port. ACT (when lit or blinking) shows Activity, and
LINK (when lit) shows that the DSL port is connected.
Note
On VDSL-ADSL models (/AVA and /AVB)
only, the Activity LED has no function.
