Installing the SmartNode device
34
SmartNode 5540E & 4140E Series User Manual
4
• SmartNode Installation
Refer to Appendix
on page 58 for interface port pin-outs.
Connecting the power supply
If you are connecting a Patton AC to DC power adapter (part no. 2500005) to the SmartNode device, go to
section
“Installing the Patton AC to DC power adapter”
. Otherwise, go to section
Installing the Patton AC to DC power adapter
Do the following to connect AC to DC power adapter (see
) to the SmartNode device:
Figure 10. Patton AC to DC power adapter
1.
Verify that the Patton AC to DC power adapter’s AC power cable is compatible with local power standards.
If it is not, refer to Chapter 6,
“Contacting Patton for Assistance”
on page 44 to find out how to replace it
with a compatible cable.
Note
Positive and negative leads are pre-terminated in the terminal block connec-
tor when using the Patton AC to DC power adapter (part no. 25000005).
2.
Remove the unneeded terminal block connector from the SmartNode device’s terminal block socket, then
plug the AC to DC power adapter connector into the socket.
3.
Plug the AC power cable that came with the AC to DC power adapter into the adapter.
4.
Plug the other end of the AC power cable into an AC power receptacle.
Note
The SmartNode device does not have a power switch; it powers on when the
device is plugged in.
5.
Verify that the green
POWER
LED is lit (see
on page 35). It blinks quickly during bootloader
phase and blinks slowly during the boot process. It stay lit constantly when the system is up and running.
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
