Installing the SmartNode device
36
SmartNode 5540E & 4140E Series User Manual
4
• SmartNode Installation
3.
Insert the positive lead into the opening on the terminal block labeled
+
and the negative lead into the
opening on the terminal block labeled
-
.
4.
Tighten the screws on the block to secure the wires.
5.
Apply power to the power source.
Note
The SmartNode device does not have a power switch; it powers on when the
power source is activated.
6.
Verify that the green
POWER
LED is lit (see
on page 35). It blinks quickly during bootloader
phase and blinks slowly during the boot process. It stay lit constantly when the system is up and running.
Congratulations, you have finished installing the SmartNode device! Now go to Chapter 5,
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
