Introduction
55
SmartNode 5540E & 4140E Series User Manual
C
• Cabling
Introduction
This section provides information on the cables used to connect the SmartNode device to the existing network
infrastructure and to third party products.
Ethernet
Ethernet devices (10/100/1000 Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. All
Ethernet ports on the SmartNode device are Auto-MDX. Use any straight or crossover cable to a host, hubs,
switches, PCs or other devices.
Note
Connecting both Ethernet ports to the same switch will only work if the
switch has a separate ARP table for each connection.
Figure 17. Typical Ethernet straight-through cable diagram for 10/100Base-T
The interconnecting cables shall be acceptable for external use
an shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
