Default IP Settings
16
SmartNode 5540E & 4140E Series User Manual
1 • SN5540E/SN4140E Series Quick Start
Default IP Settings
SN5540E and SN4140E/2ETH Models:
•
ETH 0/0: DHCP Client
•
ETH 0/1: DHCP Server:
-
192.168.1.1 mask 255.255.255.0
-
or (smartnode.local)
SN4140E Models (with 1 Ethernet port only):
•
ETH 0/0:
-
192.168.200.20 | 255.255.255.0
-
DHCP Client
Default Login
Username:
admin
Leave the password empty
Press the
Enter
key after the password prompt.
Analog Port Pinout
FXS and FXO ports use an RJ-11 connector with 6 positions. The middle 2 positions (3 and 4) are used as
shown in
Note
Pins not listed are not used.
You are responsible for creating a new administrator account to maintain system secu-
rity. Patton Electronics accepts no responsibility for losses or damage caused by loss or
misuse of passwords. Refer to Chapter 4 “Accessing the CLI”, section “Selecting a secure
password” in the
Trinity Command Line Reference Guide
for more details.
IMPORTANT
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
