SmartNode devices overview
21
SmartNode 5540E & 4140E Series User Manual
2
• General information
On the products the following model code conventions apply:
•
JS
stands for FXS ports
•
JO
stands for FXO ports
•
V
stands for the number of VoIP calls
Note
For a complete listing of available models, refer to the SmartNode VoIP page
at
https://www.patton.com/products/voip-comparison.asp
.
Table 3. SN5540E LEDs, ports, and button
Port
Description
Gigabit Ethernet ports
ETH 0/0 & ETH 0/1
RJ-45 connectors that connect the SmartNode device to an Ethernet device
(e.g., a cable or DSL modem, LAN hub or switch). These are LAN/WAN con-
figurable.
Analog voice ports,
FXS 0/0–0/7
FXS RJ-11(6 position, 4 wire) connectors that connect the device with an
analog terminal (a telephone, for example). FXS on-hook voltage is 48V
for each FXS port.
Analog voice ports,
FXO 0/0–0/7
FXO RJ-11 (6 position, 4 wire) connectors. These ports connect to FXS
devices such as the PSTN.
USB 2.0 port
USB 2.0 host port used to connect a USB 3G/4G cellular modem. A list of
supported USB models can be found here
12–48 VDC power terminal
block
The SmartNode device requires 12 VDC, 1.25 A power for operation.
POWER LED
When lit, indicates power is applied. Blinks fast during bootloader phase
and blinks slow during the boot process. Constantly lit when the system
is up and running.
VOIP LED
•
When lit, indicates the SmartNode device is registered to a SIP
server, or a SIP device has registered to the SmartNode device.
•
Off indicates the unit is not configured or registered, or has no active
directly routed VoIP connection.
ETH 0/0 & ETH 0/1 ports
Link/Activity LED (green)
On
: Connected to network
Flashing
: Data is received or transmitted
Off
: Not connected to network
ETH 0/0 & ETH 0/1 ports
1 Gbps Link LED (yellow)
On
: Connected to network at 1 Gbps
Off
: Connected to network at 10/100 Mbps or not connected to network
Reset button
The reset button has several functions, as described in appendix F,
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
