Introduction
64
SmartNode 5540E & 4140E Series User Manual
F
• Reset Button Functions
Introduction
The
Reset
for the SN4140E or
on page 65 for the SN5540E) is used to do the
following:
•
Reboot the SmartNode device (see section
“Resetting the SmartNode device when it is operating and the
•
Erase the
startup-config
settings, which is followed by a SmartNode device reboot as indicated by the slow
blinking of all LEDs (see section
“Resetting the SmartNode device when it is operating and the POWER LED
•
Factory reset, which is followed by a device reboot as indicated by the fast blinking of all LEDs (see section
“Resetting the SmartNode device when it is operating and the POWER LED is lit”
Figure 22. SN4140E
Reset
button
Summary of Contents for SmartNode 5540E Series
Page 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Page 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Page 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
