PAUL ANTHONY Eco Dry H1316, Operating Instructions Manual

10

www.lloytronhelpdesk.com

This appliance must be protected by a 7 Amp fuse in a 13 Amp type (BS1363) plug. 

Should you need to replace the fuse, use only an ASTA approved BS1362 fuse.

UK PLUG REWIRING

7A FUSE

(L) LIVE

(N) NEUTRAL

Your appliance operates on 220-240V~50Hz AC Mains and comes fitted with a 3-pin BSI Approved plug, so 

that it is ready for use by simply plugging into AC Mains. Should you need to change or refit a plug, proceed 

as follows: -

    IMPORTANT:

The wires in the mains lead are coloured in accordance with the following code:

BLUE: 

  NEUTRAL 

(N)

BROWN: 

  LIVE 

(L)

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings 

identifying the terminals in your plug, proceed as follows:

The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.

The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured RED.

    DO NOT CONNECT EITHER WIRE ‘L’ OR ‘N’ TO THE EARTH TERMINAL OF A 3-PIN PLUG

Always ensure that the Mains Cord is located into the Plug through the Cord Guard or Cable Clamp, and that 

the Cord Guard screws are tightened to clamp the Cord (outer sheath and inner coloured wires) in position 

in the Plug. Make sure the Plug top is also fitted securely.

The supply cord cannot be replaced. If the supply cord is damaged, the appliance should be scrapped.