16
Mounting
The distances from adjacent surfaces shown in Fig. 8 must be observed. Please note that these are not shown to
scale. The surfaces are allowed to be made from flammable materials:
Fig. 8: Distances from adjacent surfaces in mm
Make sure you leave at least 1 m clearance in front of the FOCUS unit for subsequent maintenance
work.
The FOCUS unit must be installed horizontally. Before mounting the unit on a wall, check that the wall construction
has the necessary load-bearing capacity (net weight of the FOCUS unit is 25 kg) and that the fastening sheet can be
mounted securely. In case of unsuitable walls, we recommend using the floor stand for fitting to the floor (optionally
available). This prevents potential transfer of structure-borne noise as much as possible.
Wall mounting
Proceed as follows for wall mounting:
1. Mount the supplied fastening sheet
A
horizontally on the wall with the lugs
B
pointing upwards. Use the slotted
holes
C
to fix it in place with suitable fixing materials.
Fig. 9: Fastening sheet for wall mounting
A
B
C
Summary of Contents for FOCUS 200 Base
Page 1: ...Translation of the original instruction manual Heat Recovery Unit FOCUS 200 Base...
Page 30: ...30 Dimensions Fig 33 Dimensional drawing...
Page 31: ...31 FOCUS 200 Base terminal scheme Fig 34 Terminal assignment terminal plan...
Page 36: ...36 PDE Manual_Focus 200 Base_V1 1 V1122 DE Subject to change...
