28
Swapping the heat exchanger for the summer box
The summer box is not capable of transferring heat or moisture. Instead, this module can be used to
replace the heat exchanger for summer ventilation while maintaining a supply air and extract air
mode!
In doing so, proceed as follows:
1. Perform work steps 1 to 6 as described in 5.5.1.
2. Insert the summer box module and perform work steps 9 to 10 as described in 5.5.1.
Display of working conditions on the control board
The control board is equipped with three LEDs for signalling working conditions.
The following working conditions are shown based on the LED display in Table 10:
LED
Signal
Condition / Cause
LED 1
Lights up
Unit ready for operation / operating voltage present
LED 2
Lights up dimly
Normal operating mode
Blinking
Temperature too low downstream of pre-heater; fans to be
switched off
Blinks 2x per second
Temperature downstream of pre-heater < 1K below limit value
Blinks 3x per second
Temperature downstream of pre-heater < 2K below limit value
Blinks 4x per second
Temperature downstream of pre-heater < 3K below limit value
LED 3
Lights up
Pre-heater heating up
Table 10: Overview of how working conditions are displayed
Technical description
Air connection design versions
Version with air connections on LEFT
Version with air connections on RIGHT
Table 11: Overview of air connection design versions
Technical specification
General specifications
Description / Value
Heat exchanger type
Cross-counterflow heat exchanger made from plastic
Housing / Interior lining
Galvanised sheet steel, powder-coated, free of thermal
bridges; interior lining is made of expanded polypropylene
(EPP) to provide thermal and sound insulation
Pipe connections
DN 125 (sleeve size)
Weight
25 kg
Electrical connection
230 VAC, 50-60 Hz;
2 m mains cable with CEE 7/4 plug
Connection power
140 W / 840 W (without/with Iso defroster heater DN 125)
Protection class
I
Degree of protection
IP 30
Temperature range for transport and storage
-20 to 50 °C
Temperature range for moving air
-20 to 50 °C
Temperature range at the mounting location
Permanently frost-free
Mounting position
Horizontal wall mounting or on a floor stand (optional)
Table 12: General specifications
Summary of Contents for FOCUS 200 Base
Page 1: ...Translation of the original instruction manual Heat Recovery Unit FOCUS 200 Base...
Page 30: ...30 Dimensions Fig 33 Dimensional drawing...
Page 31: ...31 FOCUS 200 Base terminal scheme Fig 34 Terminal assignment terminal plan...
Page 36: ...36 PDE Manual_Focus 200 Base_V1 1 V1122 DE Subject to change...
