5
1
Introduction
General
This translation of the original instruction manual contains instructions and information on the safe operation, correct
installation, operation and maintenance of the Focus 200 Base ventilation unit.
Subject to change and all rights reserved.
This documentation has been compiled with the utmost care. However, no rights can be derived from this regarding
the publisher’s liability for damages due to missing or incorrect information in this documentation. As a result, it is
possible that the unit may deviate slightly from this description. In the event of disputes, the German version of the
documentation shall be binding.
•
Read the instructions in full before installing and commissioning the ventilation unit. This will help you avoid
hazards and errors.
•
Be sure to observe all safety notes, warnings and information on precautionary measures.
•
The instruction manual constitutes a part of the product. Keep the manual for future reference.
Questions
You can address all questions and request the most recent manuals and new filters from your Zehnder
representative. The contact information is found on the back cover of this manual.
Validity
This document applies to the following unit types:
•
FOCUS 200 Base series (Zehnder Focus 200 Base series)
All the units in the FOCUS 200 series are referred to below using the generic product name FOCUS, except where it
is necessary to distinguish between specific types.
This instruction manual deals with the various design variants of the FOCUS heat recovery unit. Possible accessories
are only described to the extent necessary for appropriate operation of the unit. Please refer to the respective
instructions for further information on accessory parts.
Target groups
This instruction manual is for users and qualified personnel. The activities are only allowed to be carried out by
appropriately trained personnel who are sufficiently qualified for the respective work involved.
Qualification of target group
1.3.1.1 Users
Users must be instructed by qualified personnel as follows:
•
Instruction in hazards when handling electrical devices
•
Instruction in the operation of the FOCUS unit
•
Instruction in the maintenance of the FOCUS unit
•
Knowledge of and compliance with this manual, including all safety instructions
1.3.1.2 Qualified personnel
Qualified personnel must have the following qualifications:
•
Training in dealing with hazards and risks when installing and operating electrical devices
•
Training for the installation and commissioning of electrical devices.
•
Knowledge of and compliance with the locally applicable building, safety and installation regulations of the
relevant local authorities or municipalities, the regulations of the water and electric utilities and other official
regulations and guidelines
•
Knowledge of and compliance with this document, including all safety instructions
Conformity
The Focus 200 Base series ventilation units from the manufacturer
Zehnder Group Zwolle B.V.
Lingenstraat 2 ● 8028 ● PM Zwolle
-
NL ● Tel.: +31 (0)38
-4296911
Zwolle commercial register 05022293
comply with the directives and standards of the EU Declaration of Conformity.
Summary of Contents for FOCUS 200 Base
Page 1: ...Translation of the original instruction manual Heat Recovery Unit FOCUS 200 Base...
Page 30: ...30 Dimensions Fig 33 Dimensional drawing...
Page 31: ...31 FOCUS 200 Base terminal scheme Fig 34 Terminal assignment terminal plan...
Page 36: ...36 PDE Manual_Focus 200 Base_V1 1 V1122 DE Subject to change...
