2 Dismounting of the insulation [specialist]
10
993xx3x-inf-ml – V01
2017/08
2
Dismounting of the insulation [specialist]
The dismounting of the HeatBloC insulation must be carried out in a specific sequence
in order to avoid damages of the insulation.
Attention: The pump plug can only be removed if the lower insulating shell of the HeatBloC
has been taken off before! Otherwise there is a risk of causing damage to the insulation.
1.
Unmixed / mixed HeatBloC:
Remove the insulating front shell
of the distribution manifold.
2.
Push the insulating back shell
backwards as much as possible.
3.
Mixed HeatBloC:
Remove the actuator from the
mixing valve of the mixed HeatBloC.
4.
The actuator is still connected
to the HeatBloC via the cable.
