PawHut D00-140, Assembly Instruction Manual

3. Attach  the  push  rod: Attach  the  push  rod  mounting  tubes  to  the  frame  on  the  rear 

pusher seat. Insert push rod into the fastening parts until security locked.

Hitching the Trailer on the Bicycle

NOTE: The universal hitch is only suitable for bicycle with full axle or/and with quick 
release axle.

1. Bicycles with Full Axle
Remove  the  left-hand  axle  nut  from  the  bicycle.  Any  spacers  or  washers  can 
generally be retained. Put the hitch on the axle and re-attach the nut.
WARNING: The axle nut must be tightened on the axle thread by at least 5 full turns, 
so that adequate clamping force is ensured. A thread which is too short can result in 
accidental loosening of the rear wheel and therefore cause serious injury or death. If 
in doubt, contact your specialist dealer.

2.Bicycles with Quick Release Axle Remove the quick release from 
the bike and guide it through the hitch along with the quick release 
axle. Push the quick release through the wheel hollow axle again, 
screw the nut and clamp the quick release with the correct 
pressure.
In order to ensure that the hub is clamped sufficiently in the hollow 

axle,  the  quick  release  lever  must  begin  gripping  as  it  moves  from  the  open  to  the 
middle  position,  and  approaching  the  closed  position  you  should  clearly  feel 
resistance  as  you  tighten.  If  it  is  too  easy  or  too  difficult  to  move  the  quick  release 
lever, tighten or loosen the quick release nut on the other side of the hub.

WARNING: 

The  thread  of  the  quick  release  nut  must  be  tightened  on  the  quick 

release  axle  by  at  least  5  full  turns,  so  that  adequate  clamping  force  is  ensured. A 
quick  release  axle  with  is  too  short  can  result  in  accidental  loosening  of  the  rear 
wheel and therefore cause serious injury or death. If in doubt, contact your specialist 
dealer.
Insert the safety pin through holes in both hitch and hitch connectors. Rotate and lock 
up the pin.
Wrap  the  safety  strap  around  the  chain  stay  and  fasten  it  to  the  tow  bar  D-ring  with 
the snap hook.
WARNING!  Hitch  and  safety  strap  must  be  properly  installed.  Inspect  the  hitch  and 
tow  bar  frequently  for  any  damage  or  loose  fasteners.  Damaged  or  improperly 
installed can result in serious injury or death.

Loading and Unloading pets

Load  and  unload  pet  only  through  the  rear  door,  with  the  front  door  closed  and  the 
trailer  attached  to  the  bicycle.  With  the  pet  inside  the  trailer,  snap  one  end  of  the 
safety  leash  (included)  to  the  pet's  collar  and  the  other  end  to  the  D-ring  located 
inside the trailer. Adjust the length of the leash so that the pet cannot exit through the 
front window when it is open. Always close the rear door while riding.

EN