Console Commands
4-3
4.
To view the current wireless settings, type
sh en
(show wireless
settings) or
sh nw
(show network settings) and press
Enter
:
WiFi Mode = INFRASTRUCTURE
WiFi SSID: ABC123
Speed = 54
International Roaming: Flexible
Dynamic Frequency Selection: Unsupported
Regulatory Domain = USI
WiFi FW Ver = 2.13.10.0 LMAC, 2.12.18.0 UMAC
AP density = LOW
Authentication type= OPEN SYSTEM
Encryption is Disabled
Local certificate loaded
AP MAC Address = 00 A0 F8 51 B4 FC
Signal Quality = Excellent (100%)
Connected to SSID ENG4121 on channel 11
5.
To show the current IP settings, type
sh ip
(show TCP/IP
settings) and press
Enter
.
IP is enabled
IP address
192.0.0.192 Boot tries 3
Subnet mask 255.255.0.0 Boot method AUTO
IP Gateway
192.1.1.192 Max window 10240
(via DHCP 192.2.2.192)
LPD banner
disabled Timeout 0 min
LPD retries are disabled Keepalive 1 min
Service Port
TCP port
PXR1E8580_X1 X1
9100
6.
To change the SSID, type
set en ssid testsystem
and press
Enter
.
7.
To set the IP address, type
set ip ad 192.0.0.192
and press
Enter
.
8.
To set the subnet mask, type
set ip sub 255.255.0.0
and
press
Enter
.
9.
Type
INIT
and press
Enter
to save the settings and initialize the
unit.
10.
Type
EXIT
to exit Telnet.
Summary of Contents for Monarch 9860
