Enrolment Card - must be presented when the system is first
powered on
1. Take the enrolment card from the new pack of user cards
2. Present the enrolment card to the reader
3. The reader will beep as the enrolment card is acknowledged
4. All cards in the pack are now valid. The enrolment card can now be returned to it’s pack.
Door open time (seconds)
1. Take the door open time function card from the starter pack.
2. Present the card to the reader. The reader will start beeping.
3. Wait for the required period you wish the door to remain open.
4. Present the card again at the end of the period to set the open time. The beeping will stop.
When the battery has discharged to within the 3.5-4V minimum operating threshold, the user will experience a
delay between the card being read and access being granted. This delay acts as a warning that the battery pack is
low and should be replaced.
As an example; the initial delay will be 5 seconds. The user will present their card as normal and the green LED
will flash slowly for the 5 second delay, after which access is granted normally.
The delay will increase in increments up to 25 seconds as the battery continues to discharge.
Low battery warning
Silent operation
1. Take the silent operation function card from the starter pack.
2. Present the card to the reader. The reader will beep.
3. The reader is now in silent operation mode.
4. Present the card again to disable silent operation mode. The reader will beep twice.
Recovery from a flat battery
Should the battery pack become discharged, the unit will no longer function and the
door mechanism will then fail to operate - this could be in the locked or unlocked
state.
There is provision on the underside of the lock to apply an external PP3 9V battery
that will provide voltage to allow the circuitry to operate as normal. The +ve terminal
is the Right of the pair.
NOTE: This does not release the lock directly but allows the door to be opened with
a valid user card. Once the door is open, access to the lock will allow the internal
battery pack to be replaced.
+ve
-ve
The system will also accept colour zone function cards
