Paxton 900-100BL, Manual

12

m4

11

90˚

10

9

m4 x 16mm

16

15

2

1

14

m4 x 10mm

13

-Don’t over tighten

-ne pas trop serrer

-niet te strak trekken

-Nicht zu eng anziehen

-No sobreajuste

-Dra inte åt för hårt

-Draai niet te vast

-Não aperte demasiado

-Ne húzza meg túlságosan

-Undlad at overspænde

!

Hand the PaxLock Pro to suit the 

door. 

Then secure the chassis to the body 

using the 2 m4 x 16mm bolts 

provided.

Feed the through door bolts and 

spindle through the lockset 

ensuring it sits flush against the 

door face.

Discard or recycle the paper straws.

Feed the battery side chassis over 

the bolts and spindle. 

Thread the supplied m4 nuts over 

the wires and onto the bolts.

Tuck the wires behind the PCB so 

they do not obscure the circuit 

board.

Unclip the 4 connector blocks. 

Insert each colour wire into its 

corresponding coloured connector 

and close the connector block until 

you hear a click. 

NOTE: Do NOT strip the wires.

Screw the self-tapping m4 x 10mm 

wood screw into the door.

Tighten the m4 nuts with the box 

spanner provided

Caution: Over tightening can 

cause the back plate to bow. Only 

hand tighten using the box 

spanner provided.

4