P a y R a n g e | B l u K e y P r o | U s e r M a n u a l
P a g e
6 | 23
4‐pin connector is not used (no card reader) ‐ Use C4/D4 harness
4‐pin connector is used (machine has card reader)
o
Pulse mode: Use C7/D7 harness if coin slot is not installed, and C8/D8 harness if
coin slot is installed. Harness power connector will have to be cut off and wires
spliced to machine 24VAC power.
o
Serial mode: NetMaster not supported in pulse mode.
2.
Maytag and Some Whirlpool Machines
a.
Px type (with 6‐pin connector)
If machine has control board with 6‐pin cashless connector:
6‐pin connector is not used (no card reader) ‐ Use C3/D3 harness
6‐pin connector is used (machine has card reader) – Use C3/D3 harness and connect
card reader to “CARD” with appropriate card reader harness.
b.
ADC type (without 6‐pin connector)
If machine has control board without 6‐pin cashless connector:
If machine has no card reader – Use C6/D6 harness
If machine has card reader installed: contact PayRange for support.
3.
LG Machines
a.
C type
If machine has front panel harness with cashless connectors:
cashless connectors are not used (no card reader) ‐ Use C5/D5 harness
cashless connectors are used (machine has card reader) – Use C5/D5 harness and
connect card reader to “CARD” with appropriate card reader harness.
4.
Other Machine Types
Contact PayRange for support.
Installation Steps
These are generic installation instructions. Each individual machine and harness may have
additional steps or details relevant to installation.
1.
Disconnect power from the machine
2.
Open machine cabinet
Unlock panel with operator/service key, position the panel as necessary for service.
3.
Connect harness to BluKey Pro
