P a y R a n g e | B l u K e y P r o | U s e r M a n u a l
P a g e
7 | 23
4.
Connect Coin Acceptor connectors:
a.
Disconnect machine’s Coin Acceptor harness connector (if present)
b.
Plug in pass‐through Coin Acceptor connectors into Coin Acceptor connector and
machine’s harness connector
If Coin Acceptor is not present on the machine but machine has Coin Acceptor harness, plug in
only one connector.
Coin Acceptor is not required for BKPro operation.
5.
Power up the machine (leave the control panel open)
6.
BluKey Pro should power up and turn on solid blue LED
See section “Troubleshooting / Light Codes” on page 11 if BluKey Pro does not power up or does
not turn on solid blue LED.
7.
Configure BluKey Pro
See section “BluKey Pro Device Configuration ” on page 8.
8.
Configure machine
See section “Machine Controller Programming” on page 7.
9.
Power off the machine
10.
Place wires and BluKey Pro inside the machine
Fix BluKey Pro with adhesive fastener tape.
11.
Close machine control panel
12.
Power up the machine
13.
Verify machine operation
Check mobile payment, coin payment, start cycle and verify that PayRange app shows “Machine
in Use”
Machine Controller Programming
BKPro can connect to various payment accepting inputs: coin, debit, serial. Depending on machine,
harness and chosen operation mode (pulse or serial) of BKPro, machine should be programmed to work
in the chosen mode and have the input activated. Follow the below sections to program Laundry
machine.
