PAYTEC
user guide CV3516
page 7/14
Warning!
The mini-DIP switches 15 e 16 have to be set to the OFF position when
activating the teach mode, otherwise the coin selector software blocks the
two channels for the teach mode.
If any coin blocking switches are activated (ON) for channels which are
not released for the teach mode, the coin selector magnet will operate
briefly three times to indicate an incorrect operation.
For security reasons during teaching, the token channel can be
programmed when the measured values of the tokens do not overlap the
values of the coins programmed, with mini-DIP switch 7 on OFF (broad
tolerance). Should the programming not be successful when using broad
tolerance, teaching could be still possible using the narrow tolerances
(mini-DIP switch 7 on ON).
The teach mode is deactivated by setting mini-DIP switch 8 on OFF. When
the teach mode is deactivated, all mini-DIP switches may then be used
for individual coin blocking with the exception of mini-DIP switch
3.1.
Parallel Output Connector
The parallel output connector is a 10-pin, dual row jack. The connector
has the following pin out:
Pin No.
Connection
1
GND
2
+Vcc
3
coin output 5
4
coin output 6
5
-
6
general blocking (input)
7
coin output 1
8
coin output 2
9
coin output 3
10
coin output 4
Fig. 4
10-pin male connector
