Date: 2013-May-27
www.pbteen.com
Page 4 of 5
Rev:
8. Thread the 3 Support Legs (H) into the pre-fixed insert nuts of the Support Rail (G), as seen in the illustration
below.
9. Attach the assembled Support Rail (G) and Support Leg (H) to the Slats Roll (F).
10. Connect the 1
st
slat to one end of the Support Rail (G) by inserting Bolt (J), Spring Washer (L), and Flat
Washer (M) through the pre-drilled holes of the 1
st
slat and into the pre-fixed insert nuts of Support Rail (G),
as seen in the illustration below.
