Hampton Basic Queen Bed
PRE-ASSEMBLY:
1.
Please read all instructions carefully before beginning assembly.
2.
For your safety, assembly by two adults is recommended.
3.
Save all packing materials until assembly is complete to avoid accidentally discarding smaller part/ hardware.
PARTS ENCLOSED:
A – Headboard – 1 pc
B – Footboard - 1 pc
C - Side rail – 2 pc
D - Center Rail – 1 pc
E – Leg – 3 pcs
F - Roll of 16 connected slats – 2 pcs
HARDWARE ENCLOSED:
G - L-bracket 45 x 55 x 50 mm – 2 pcs
H - Phillips head screws M4 x 16 mm – 8 pcs
I - Rattan screw M4 x 45 mm – 6 pcs
J - Rattan screw M4 x 30 mm – 64 pcs
TOOLS REQUIRED BUT NOT INCLUDED:
•
Phillips Head Screwdriver
ASSEMBLY:
1.
The slot is designed with two adjustable levels. At your desired height, hold Side Rail (C) up to slots on the legs of the Headboard (A) and
insert the hooks of each Side Rail (C) into the slots. Push down firmly on the top of Side Rails (C) until they seat themselves over the pins
inside the leg slots as shown. Repeat the same procedure with the Footboard (B).
C
A
F
D
E
B
Note: Ignore the E-nuts.
Use slot only.
2.
Fasten the Leg (E) to the Center Rail (D) with Rattan screw (I). The Leg (E) may not attach to the ground. Determine which end does not
touch the ground correctly and adjust the leveler at the Leg (E) until the Leveler sits firmly on the ground.
C
B
A
3.
Locate the up arrow label on L bracket (G) and fasten the L-bracket to the Center Rail (D) with Phillips head screw (H) as shown.
4.
Once both the Legs and L brackets are attached to the center rail, the rail will then be secured to the headboard and footboard. Position the
center rail so that the screw holes of the L-bracket align with the pre-drilled holes located in the center of Headboard & Footboard. Use
Phillips head screw (H) to fasten the connection for both ends with screwdriver.
E
D
I
D
H
G
D
D
