ООО «ТЛК Трейд» | 196158, г.Санкт-Петербург, Пулковское шоссе, д.30, корп.4, оф. 213В (юр.) | ИНН 7810592830 КПП 781001001
р/с 40702810068000007550 | к/с 30101810200000000704 | Филиал ОПЕРУ ОАО Банк ВТБ в Санкт-Петербурге | БИК 044030704
ОКПО 66035862 | ОКАТО 40284565000 | ОГРН 1107847196060 | т.(812)6499888 | http://www.tlct.ru http://www.rftel.ru
ООО «ТЛК Трейд», Санкт-Петербург
+7 812 64 99 888
mail@tlct.ru
Uni/Multi IP Address: set the destination IP address
Uni/Multi Address:
238.069.070.001
Uni/Multi UDP Port: set the destination port number, valid
range from 1~65535
Uni/Multi UDP Port: 01234
ProMPEG FEC Switch: Enable/Disable
ProMPEG FEC Switch:
Disable
ProMPEG FEC Mode:
1D,5x5/1D,5x20/1D,10x10/2D,5x5/2D,5x20/2D,10x10
ProMPEG FEC Mode :
1D,5x5
FEC Alignment:
Annex A/Annex B
FEC Alignment:
Annex A
Gigabit Address: set the IP address of the IP port
Gigabit Adress:
010.010.010.010
Gigabit Subnet Mask: set the net mask of the IP port
Gigabit Subnet Mask:
255.255.255.000
Gigabit MAC Address: display the MAC address of the IP
port
Gigabit Gateway: set the gateway of the IP port
Gigabit IP Gateway:
010.010.010.001
Gigabit Local
Gateway MAC Address: set the MAC address of the gateway
under which the device is connected
Gateway MAC Address:
ff:ff:ff:ff:ff:ff:ff
Uni/Multi Address: set the uni/multicast target address of the
IP input
Uni/Multi
Addres:238.069.070.002
Uni/Multi UDP Port: set the target port number of the
uni/multicast IP input, valid range from 1~65535
Uni/Multi UDP Port: 01234
Gigabit Input
TS Clock Recovery:
Auto: it is suggested to set Auto when there is accurate PCR
carried by the inputted TS/IP
Fixed Rate: when fixed rate is selected, user has to configure
a bit rate to regenerate the TS clock. The configured fixed bit
rate has to be a little bit higher than the bit rate of the inputted
TS/IP.
TS Clock Recovery: Auto
6.2.6 Configuration – Modulation (QAM)
Submenu
Parameters
& Description
Default Value
Modulator Output
ON/OFF: put OFF to switch off the QAM carrier
ON
Output Source
Encoder1/Encoder2/Encoder3/Encoder4: the stream output
from the corresponding encoder will be delivered to modulator
directly.
Remux: the stream from built-in remux will be delivered to
REMUX
