ООО «ТЛК Трейд» | 196158, г.Санкт-Петербург, Пулковское шоссе, д.30, корп.4, оф. 213В (юр.) | ИНН 7810592830 КПП 781001001
р/с 40702810068000007550 | к/с 30101810200000000704 | Филиал ОПЕРУ ОАО Банк ВТБ в Санкт-Петербурге | БИК 044030704
ОКПО 66035862 | ОКАТО 40284565000 | ОГРН 1107847196060 | т.(812)6499888 | http://www.tlct.ru http://www.rftel.ru
ООО «ТЛК Трейд», Санкт-Петербург
+7 812 64 99 888
mail@tlct.ru
• The mounting environment should be relatively dust free, free of excessive vibration and the ambient
temperature between 0C° to 40C°. Relative humidity of 20% to 80% (non-condensed) is
recommended.
• Avoid direct contact with water.
• Never place the equipment in direct sunlight.
• The outside of the equipment may be cleaned using a lightly dampened cloth. Do not use any
cleaning liquids containing alcohol, methylated spirit or ammonia etc.
• For continued protection against fire hazard, replace line fused only with same type.
• Air intake for cooling is achieved via holes at the side of the device and the fans inside. The air flow
should not be obstructed. Therefore, the device has to be placed on a flat surface, leaving some
space at the sides of the device.
• When in operation, the internal temperature should not exceed the limit of 70C°.
DXP-5410/5411EM
4 Channel Integrated Encoder-Modulator
1 Overview
DXP-5410EM/5411EM is an integrated 4-channel real-time encoder re-multiplexer modulator. Four sets of A/V
inputs are encoded and generated 4 Transport Streams (TS) independently. TS streams from the internal
encoders, ASI input and TS/IP (TS_over_IP) input (duplex mode only) could be re-multiplexed into one MPTS
(Multiple Program TS), then modulated onto one DVB RF carrier, QAM or COFDM. This MPTS is also available
at the ASI output & TS/IP output simultaneously. There are up to 5 streams encapsulated onto TS/IP output when
TS/IP is configurated as Multi-output mode. In this mode, all 4 TS streams from internal encoder could be sent
through the TS/IP port while the fifth IP slot could be fed with the internal re-multiplexer or ASI input. With a built-
in RF back-up relay switch, any external RF signal could be fed to the main output for back-up in cases of internal
malfunction (main RF level < 75dBuV) or power supply lost.
DXP-5410EM/5411EM series are accommodated in 1U x 19” standard chassis with 2 redundant power supply
modules.
2 Features
Comply with H.264/AVC HP@L4.1
4 independent real-time encoders
Integrated 6-input TS reMUX, (4 for encoders, 1 for ASI in, 1 for TS/IP in)
