23
and is connected to the computer (see ch. 2.1.). To connect the hardware to the program, press Pair button,
then the button on the piece of equipment you intend to connect (see fig. 3.10.).
Figure 3.10 – Connecting device to the program
Base A – in the program press Pair button, then press one of the Base buttons. Hardware serial code in Base
button must match the serial number in Base A.
Base B – press Pair button then press the Base button of the next hardware piece. The serial code of second
button Base should be displayed in the Base B field.
Pit zone A – in the program press Pair button then touch the chip(tag) with corresponding ribbon to one of
the Pit zone buttons (for example with red circle). Serial code of Pit zone button must match with the code
in the field of Pit zone A.
Pit zone В – click the Pair button and then attach the chip with the matching ribbon to the second Pit zone
button (for example, with the black circle).
Referee Control – click the Pair button in the program and then click on any button on the Remote control
device.
Scoreboard – if a special scoreboard is used ( see ch. 2.6.) make sure that scoreboard is connected to a
power supply, then press Pair button in the program. Press a button on the scoreboard to connect
scoreboard to the program. The button is located on the case of scoreboard on the side next to the power
supply plug. After pressing the button Link OK will be displayed if connection was successful, or Link Error if
there was an error during connection.