7
Figure 2.6 – Electronic key/chip applied to Pit-zone button
In case the STATUS button on the Pit zone is lighting up red, check whether the color of the ribbon
matches the color of the button circle on the Pit zone. If it matches, but light indicator is not on, then
check the batteries on the device. To do so, turn the Pit zone button around and remove 4 screws.
Replace the old batteries with new ones and screw the lid back on.
2.2.1.
How to add an electronic key to the Pit zone device
In case of adding additional electronic keys (no more than 10 units) to the Pit zone device, follow these
instructions:
1. Purchase new electronic keys.
2. Turn the Pit zone device around and unscrew the 4 screws and take the lid off.
3. Push the Add key button (see Fig. 2.7). After that, the status indicators STATUS will start to blink
alternately (green light) and «Lock» (red light).
4. While indicators are blinking attach the electronic key to the Pit zone device.
5. The green STATUS light will light up – a new electronic key is connected and programmed. If a red light
ignites «Lock» - the electronic key is not connected, repeat point 3 and 4.
6. In order to add the following key repeat points 3 to 5.