Confidential
Page 5
4/23/2008
PC-EFTPOS Hardware Installation
PX328 EFTPOS PINpad
Supplied Equipment with terminal:
EFTPOS PINpad
PINpad Power Supply
Installation Steps
1.
Plug the supplied power adaptor into a
power point
2.
Connect the power supplies DB9 connector
into the PC Com Port that will be used for the
PINpad
3.
Plug the PINpad into the RJ45 connector on
the powered adaptor
NPT-710 EFTPOS Terminal
Supplied Equipment with terminal:
NPT-710 Terminal
Power brick and cord
POS connector cable (RS232 Cable)
Dial-up phone cable
Installation Steps
1
. Power the terminal. Connect the brick and
cord then plug into a power point.
2.
Connect the power adaptor to the power
socket on the back of the terminal
3.
Connect the RS232 cable (supplied) to the
COM port on the back of the PC (normally
COM 1)
4.
For a terminal integrated to a POS, connect
the other end of the RS232 cable to the RS232
connector on the back of the terminal. (The
slot next to the power supply)
5.
If the terminal is using the internal modem,
plug the phone cable in to the phone connector
on the back of the terminal.
Hardware Installation