PAGE 3
SENSO
RS AN
D INS
TRUME
N
TATI
O
N F
O
R MAC
HINE
CON
DITI
ON M
ON
IT
ORIN
G
Introduction
The Model 683A1 ICP
®
Process Indicator/Controller is an
intelligent 4-digit modular panel meter with software
features for monitoring, measurement, and control applications complete with 0.56
”
LED in a 1/8 DIN 96x48 case.
The 683A1 operates from a single power supply and will supply 24Vdc/4mA excitation for sensor power. The
indicator/controller comes equipped with two 5 Amp Form A relays with independent setpoints and time delay.
General Features
External transmitters, signal conditioners, or power supplies can be eliminated by direct connection of the
sensor to the indicator/controller.
Optional isolated 16-bit analog output. User or factory scalable to 4 to 20 mA across any desired digital
span from ± one count to the full-scale range of
–
1999 to 9999 (12000 counts).
24Vdc/4mA excitation to power sensor.
Standard Internal DIP switch selectable vibration ranges include:
Acceleration (g
’
s)
Velocity (in/sec)
Displacement (mils p-p)
5.000
0.500
25.0
10.00
1.000
50.0
20.00
2.000
100.0
Two 5 Amp Form A relays, additionally two 5 Amp Form A or 10 Amp Form C relays are available.
Programmable Time Delay to 9999 seconds.
Internal DIP switch selection for Peak or RMS display.
User specified, factory installed, High and Low pass 2-pole filtering.
Analog output signal connection (RV) for conducting frequency analysis and machinery diagnostics.
Software Features
Three-button front panel programming of:
Scale Factor and Offset
Decimal point setting.
Four-level brightness control of digital display.
Peak and valley view and reset.
Four programmable setpoints.
Adjustable delay-on-make and delay-on-break time for setpoints 1 and 2.
Relay activation can be selected to occur above (HI) or below (LO) each setpoint.
Summary of Contents for IMI SENSORS 683A101001
Page 30: ......
