Hardwa
re Monitor Page
Features Setup Page
This page sets some of the parameters for peripheral devices
installed on the system.
Onboard FDC
Use this item to enable or disable the onboard
floppy disk drive interface.
Onboard Serial
Port1
Use this item to enable or disable the onboard
serial port COM1, and to assign a port address
Onboard IR Port
Use this item to define the protocol for an
infrared port if you have installed an optional IR
port.
IR Duplex
Use this item to define if the optional infrared
port is full-duplex or half-duplex.
Onboard Parallel
Port
Use this item to enable or disable the onboard
parallel port LPT1, and to assign a port address
Parallel Port Mode
Use this item to determine the parallel port
mode. You can select Normal, ECP (Extended
Capabilities Port), EPP (Enhanced Parallel
Port), or ECP + EPP.
Parallel Port IRQ
Use this item to assign an IRQ to the parallel
port.
Parallel Port DMA
Use this item to assign a DMA channel to the
parallel port.
35
