-3-
1.
Plug the transmitter into a wall outlet and the LED
lights.
2.
Check the unit as the UNIT TEST section says.
3.
Put the receiver near the breaker panel box at a
correct angle and directly on circuit breaker or fuse,
as shown in figure 2.
4.
Move the receiver up and down slowly over the row
of circuit breakers or fuses while lowering the
sensitivity of the receiver by adjusting the wheel until
only one breaker or fuse causes the receiver to beep.
( In certain instances an adjacent breaker or fuse
may cause a beep due to the routing of the wires ).
5.
You can turn off the circuit after locating the right
breaker or fuse, then the receiver will stop beeping.
6.
Check the red LED on the transmitter in the outlet is
off to confirm that you have turned the right breaker
or fuse off.
How to Use
PCE-191 CB
Locate Circuit Breaker or Fuse
