10
The Sampling Setup field instructs the DATA
LOGGER to log readings at a specific rate . You
can input specific sampling rate data at the left
Combo box and select the time unit at the right
Combo box.
The Motion Detection Threshold Setup filed
allows the user to set the acceleration detection
threshold.Once the acceleration value is over the
threshold,the DATALOGGER will work.
The LED Flash Cycle Setup field can be set
10s/20s/30s by the user depending on the
requirement. By selecting “No Light” option, there
will be no flash there by increase the battery life.
The DATA LOGGER Record Mode can be set as
Normal and Motion Detection.
Free-fall Detection field can be set for detecting
Free-fall events or not.
The Manual and Automatic select buttons allows
the user to start data logging immediately when
exit the Setup window(Automatic) or at a later
time (Manual).
Click on the SETUP button to save changes. Press the
DEFAULT button to set the Logger to factory default
condition. Press the CANCEL button to abort the setup.
Notes:All stored data will be permanently erased when
Setup is finished. To enable you to save the data before it is
lost, click Cancel and then you need to download data.
The battery might be exhausted before logger finish
specified sample points. Always ensure that the remaining
power in the battery is sufficient for completing your logging
task. If in doubt, we recommend that you always install a
fresh battery before logging critical data.
