4. MEASURING PROCEDURE
4-1 Preparation
1)Install the vibration sensor set
The complete vibration set are :
1. Vibration Sensor, 3-18, Fig 2
2. Sensor Cable, 3-21, Fig. 2
3 VB-83 module, 3-24, Fig. 2
* Plug in the " Cable BNC Plug "
( 3-22, Fig. 2 ) to the " BNC
Socket of VB-83 module "
( 3-23, Fig. 2 ).
* Plug in the " Mini plug of cable "
( 3-20, Fig. 2 ) to the " Input
socket of vibration sensor " (
3-19, Fig. 2 ).
Plug in the " Plug of VB-83
module " ( 3-24, Fig. 2 ) to the "
CH1 VB-83 Input Socket "
( 3-9A, Fig. 1 ). If you have extra
vibration sensor set, then Plug
in to the " CH2/CH3/CH4 VB-83
Input Socket " ( 3-9B, 3-9C, 3-9D
Fig. 2
Fig. 1 )
Remark :
Extra vibration sensor set, VB-83 can be ordered.
When change the VB-83, it is not necessary to make
calibration again due to the vibration detail calibration
information already save into the " VB-83 module "
( 3-24, Fig. 2 )
11
