2)1)Power on the meter by pressing the " Power button "
( 3-2, Fig. 1 ) > 3 seconds continuously.
* After already power on the meter, pressing the
" Power button " > 3 seconds continuously will
turn off the meter.
The " Display " ( 3-1, Fig. 1 ) will show the 4 channels
vibration value ( CH1, CH2, CH3, CH4 ) at the same time.
If some channels not plug in the VB-83 Vibraion set,
then the corresponding cahannel Display will show
" - - - - ".
Remark :
1.
If the surface material of measuring article is not
the ferrous material, hold the vibration sensor by
hand & touch the sensor to the surface of the
measuring article,
*
If the surface material of measuring article is the
ferrous material, connect " Vibration sensor " (
3-18, Fig. 2 ) with the " Magnetic base " ( 3-17, Fig.
2 ). Put the whole unit ( Vibration sensor &
Magnetic base ) to the surface of measuring article.
*
Please do not use the finger or hand to touch the
the " Sensor cable " ( 3-21, Fig. 1 ).
4-2 Unit selection ( Acc./Velocity/Displacement
selection )
Select the desired display unit by pressing the
" ACC/VEL/DISP Button " ( 3-5, Fig. 1 ) > 3 seconds (
not release the button ), the Display will show the
following units according Acceleration / Velocity /
Displacement in sequence.
12
