5-3 Manual Datalogger ( Set sampling time = 0
second )
a. Set sampling time is to 0 second
Press the " LOG Button ( 3-8, Fig. 1 ) once , the low LCD
will show the indicator " LOGGER ", then press the " LOG
Button " ( 3-8, Fig. 1 ) once, the bottom indicator "
LOGGER " will flashing once and Beeper will sound once,
at the same time the measuring data along the time
information will be saved into the memory circuit. The lower
Display will show the Position ( Location ) no. and saved
into the SD card too.
Remark :
During execute the Manual Datalogger, it can use the "
▲
Button " ( 3-5, Fig. 1) or " Button " ( 3-7, Fig. 1 ) to
▼
set the measuring position ( 1 to 99, for example room 1
to room 99 ) to identify the measurement location , the
lower Display will show P x ( x = 1 to 99 ).
( x = 1 to 99 ).
b. Finish the Datalogger
During execute the Datalogger function, press the
" LOG Button ( 3-8, Fig. 1 ) > 3 seconds continuously
again will finish the Datalooger function, the " LOGGER "
indicator will be disappeared and finish the Datalogger.
function.
5-4 Check time information
During the normal measurement ( not execute the
Datalogger ), If press " Clock Button " ( 3-6, Fig. 1 ) )
once , the lower LCD display will present the time
information of Year/Month, Date/Hour, Minute/Second
and the Sampling time information in sequence.
19
